attansic killer e2200 gigabit ethernet controller

#ATTANSIC KILLER E2200 GIGABIT ETHERNET CONTROLLER INSTALL#

The Vendor ID and Device ID fields are required, Subsystem Vendor ID, Subsystem Device ID, Class, Class Mask, and More hardware than was included in the driver's static device ID Writing a device ID to this file will attempt to dynamically add a newĭevice ID to a PCI device driver. Short of applying the appropriate patch and recompiling the affected kernel module, you may be able to register new PCI device IDs ( documentation) with existing device drivers:

Original post (still applicable to other Ubuntu releases before 16.04) More info: Ubuntu Wiki – LTS Enablement Stack The newly installed kernel should be the new default boot option for Grub.

#ATTANSIC KILLER E2200 GIGABIT ETHERNET CONTROLLER INSTALL#

Install the kernel packages: sudo apt install linux-generic-lts-xenial Luckily one can upgrade to the same kernel in Ubuntu 14.04 via LTS/HWE upgrades: Your E2400 should now appear for your networking enjoyment!Īccording to chili555's comment on a similar question that device is supported by the kernel shipped with Ubuntu 16.04. extra/alx.ko If you do not, you may need to rename the alx.ko that it did find to alx.ko.bak or something of the sort, and run the last three commands again. Note: You after executing the last line, you should see the module load from. Sudo make -C /lib/modules/$(uname -r)/build M=$(pwd) modules_install Now, all that's left is to make and install the drivers make -C /lib/modules/$(uname -r)/build M=$(pwd) modules Once that is finished, we'll modify the alx driver to include our E2400 (feel free to use your text editor of choice) cd ubuntu-vivid/drivers/net/ethernet/atheros/alx/įind the line defining ALX_DEV_ID_E2200 (you can just search for E2200), and add this below it #define ALX_DEV_ID_E2400 0xe0a1Īgain, find E2200, and after the lines ,

That last step can take a little while, so relax and bask in the knowledge that your E2400 will soon be working. You would replace vivid with your release codename. I am posting this from my Skylake MSI Z170A GAMING M5 build using my Killer E2400 on Ubuntu Gnome! Below are the (more or less) simple steps I used to get it working.įirst we'll follow some instructions from Ubuntu sudo apt-get build-dep linux-image-$(uname -r)

Attansic killer e2200 gigabit ethernet controller